![]() Now go to the back and drop out the spare tire, it makes it much easier. Once you have put the bottom rail back on push down along the whole panel to ensure that it is clipped in the correct places. Then wrap the foam tape that came in the kit around the relays and zip tie them to a place inside there.īutton that whole side back up. The directions tell you what setup you will use for your particular vehicle, you're either going to hook up only 2 of them or all three of them. Once inside you will find 3 relays that need to have fuses added to them, depending on what way you're hooking up the harness. ![]() Pop out the 2 on the side first then just pull and the one on the floor will pop off. 1 is on the floor and 2 are on the side of the truck. Then remove the kick panel, it is held on in 3 places. Put those to the side and continue pulling it off. Those attach here on the 2 retainers (im just holding the panel up with my finger, not pointing) ![]() ***WARNING: air bag sensors are in this area on some models!!*** You start by removing the side strip first, careful pulling on it with even pressure, it is held in place by 2 white pop things. The kit comes with directions and pictures, but they are kinda messy since B&W.Īlso you will need these tools if you are planning on placing the receiver in the bumper itselfįirst go to your passenger side kick panel and remove it. The 7 pin harness I bought from the Nissan dealer for about $55. Ok, so I did most of this already and I didn't have a camera, so a few steps do not show progress, just show it finished.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |